凈化鋁材配件-防護手套的正確選用是關鍵
- 發布人：
- 發布日期：2017-04-14 09:13:55
1. 防護手套的品種很多，要根據防護功能來選用。首先應明確防護對象，然后再仔細選用。如耐酸堿手套，有耐強酸（堿）的、有耐低濃度酸（堿），而耐低濃度酸（堿）手套不能用于接觸高濃度酸（堿）。切記勿誤用，以免發生意外。
1 varieties of protective gloves, according to the protection function to choose. First of all, should be clear to protect the object, and then carefully selected. Such as acid and alkali resistant gloves, resistance to strong acid (base), tolerance to low concentration acid (alkali), and tolerant to low concentration of acid (alkali) gloves may not for exposure to high concentration of acid (alkali). Remember not to misuse, so as to avoid accidents.
2. 防水、耐酸堿手套使用前應仔細檢查，觀察表面是否有破損，采取簡易辦法是向手套內吹口氣，用手捏緊套口，觀察是否漏氣。漏氣則不能使用。
2 waterproof, acid and alkali resistant gloves should be carefully checked before use, observe whether the surface is damaged, to take a simple way is to blow the glove inside the glove, hand pinch tight set, observe whether the leakage. Can not use the air leakage.
3. 絕緣手套應定期檢驗電絕緣性能，不符合規定的不能使用。
3 insulated gloves should be regularly tested for electrical insulation properties, does not meet the requirements of the use of.
4. 橡膠、塑料等類防護手套用后應沖洗干凈、晾干，保存時避免高溫，并在制品上撒上滑石粉以防粘連。
4. Rubber, plastic and other kinds of protective gloves after use should be washed clean, dry, save to avoid high temperature, and WIP sprinkle talcum powder to prevent adhesion.
5.接觸強氧化酸如硝酸、鉻酸等，因強氧化作用會造成防護手套發脆、變色、早期損壞。高濃度的強氧化酸甚至會引起燒損，應該注意觀察。
5 contact with strong oxidizing acid such as nitric acid, chromic acid, due to strong oxidation will cause the protective gloves crisp, discoloration, early damage. High concentrations of strong oxidizing acids may even cause burning, should observe.
6.乳膠工業手套只適用于弱酸、濃度不高的硫酸、鹽酸和各種鹽類，不得接觸強氧化酸（硝酸等）。
6 latex industrial gloves are only suitable for weak acid, the concentration of sulfuric acid, hydrochloric acid and a variety of salts, not contact with strong oxidizing acids (nitric acid, etc.).
在凈化鋁材配件 http://www.jnjkjh.com/ 中，工作者會遇到各種帶電操作的情況。根據實際的工作電壓來選擇相應的電工絕緣手套，并在實際操作中，應使用電工外用手套配合電工絕緣手套一起使用，以更好地防護穿刺及撕裂的危害。每次使用電工絕緣手套的前后都應進行必要的檢查，以確保使用時的安全。
In the purification of aluminum parts, workers will encounter a variety of live operation. According to the actual working voltage to select the appropriate electrical insulation gloves, and in the actual operation, should be used in electrical and external gloves with electrical insulation gloves to use, in order to better protect puncture and tear of the damage. Every time the use of electrical insulation gloves should be carried out before and after the necessary checks to ensure the safety of the use of.
防護套袖是用以保護手上臂的防護用品。主要有：
The protective sleeve is used to protect the upper hand protective equipment. Mainly:
1. 石棉防輻射熱套袖：用于高溫爐窯等作業場所。
1 asbestos heat radiation proof sleeves: for high temperature kilns and other workplaces.
2. 鋁膜布隔熱套袖：用于高溫爐窯及其它有強輻射熱的作業環境。
2 aluminum sleeves: cloth insulation for high temperature furnace and other strong thermal radiation environment.
3.膠布防酸堿套袖：用于接觸水、酸堿、污物等的作業。
3 tape sleeves: anti acid used in contact with water, acid, dirt and other operations.
4. 塑料防酸堿套袖：用于接觸水、酸堿、污物等的作業。
4 plastic sleeves: anti acid used in contact with water, acid and alkali, dirt and other operations.
- 上一篇：凈化鋁材配件-無紡布與無塵布的區別
- 下一篇：一定要知道的空氣凈化工程防護五要點
